Instruction on how to use DJMAX RESPECT mode

To make DJMAX RESPECT mode work, special converter is necessary
To use DJMAX RESPECT mode, the latest firmware is necessary

mcp2515 proteus library

Connection about the converter


After you connect the controller according to the following steps, you can make DJMAX RESPECT mode work normally.

  1. Connect the PlayStation 2 connector of the controller to the PlayStation 2 connector of converter
  2. Connect PlayStation 4 gamepad to any USB connector in the both side of the convertor with a USB cable
  3. Connect the USB of the converter to PlayStation 4 body
  4. Connect the red USB connector of the controller to PlayStation 4 body

Buy converter now


Converter doesn’t support PS4 PRO game body for the time being.


Start game


The blue pilot light of the converter should turn green, and keep shining after flashing about 30 seconds, then you can play game mcp2515 proteus library


Mode switch

Press start+select+5, simultaneously about a second, PS2 IIDX mode and DJMAX RESPECT mode of the controller can be switched repeatedly

mcp2515 proteus library

Key Mapping


Key mapping is shown as following image


Controller PS4 key
Start left stick ↓
Select right stick ↓
1 ←
2 ↑
3 →
4 ×
5 □
6 △
7 ○
Rotate turntable clockwise left stick ↓
Rotate turntable counterclockwise left stick ↑
Controller PS4 key
Start+Select+4 Option
Start+1 L1
Start+2 R1
Start+6 R2
Start+7 L2
Start+Select+5 Switch for PS2 IIDX／DJMAX RESPECT game mode

The details of the other questions are shown in “Common Question” in the bottom of this page

Library | Mcp2515 Proteus

Overview The MCP2515 is a stand-alone Controller Area Network (CAN) controller from Microchip, implementing CAN 2.0B with support for standard (11-bit) and extended (29-bit) frames. It communicates with a host microcontroller via the Serial Peripheral Interface (SPI) and offloads CAN bus timing, message buffering, acceptance filtering, and error handling from the host. Proteus (by Labcenter Electronics) is widely used for circuit simulation and PCB design; adding an MCP2515 model or library component to Proteus enables realistic simulation of CAN-based systems alongside microcontrollers and other peripherals.